Basement Floor Epoxy
Basement slabs tested for moisture, ground and coated with epoxy, flake or polyaspartic for laundry rooms, rec rooms and home gyms around South Bend.
South Bend Premier Epoxy Flooring provides epoxy flooring in Berrien Springs, MI, including basement epoxy, garage floor coatings and polyaspartic floors for homes and businesses in Berrien Springs.
Request a quote
Tell us which floor and what it looks like today. We will call you back.
Four in ten homes in Berrien Springs date from 1939 or earlier, and a basement floor that old has usually been patched, painted and patched again. Some of those patches sit over hollow spots where the slab has let go of the ground under it. Before we quote, we tap the floor with a hammer to find them, cut out what rings hollow and test the rest for moisture.

Half the village's homes are older than 1952, and a wine, cider and brewing trade works the farms and towns around it.

The wineries, cideries and breweries around Berrien Springs work on floors that get hosed down every day and take spilled juice, wort and cleaning chemicals. A thick one-piece coating with a cove at the walls keeps liquid out of the concrete, and grit in the topcoat keeps footing sure. We plan the work around harvest and the busy weekends.

A farm shop or fruit storage building takes tractors, pallets and forklift tires. A hard film on that kind of floor can chip at the edges, so we often grind and densify the concrete instead. That leaves a dust-free surface with nothing on top to peel.
The St. Joseph River runs past the village, and it reached record levels in February 2018. If a basement took river water, the concrete holds it for months after the floor looks dry. Coat it too soon, and that water pushes the coating up in blisters. So we wait until the slab tests dry, clean off the silt and any mold, and grind it open so the primer can grip. And if water came in once, plan for a drain or sump before the floor is coated.
Many old basements were carpeted at some point. When the carpet comes up, you typically find tack strip nails along the walls, pad glue in patches and stains where water got under. Glue and carpet residue keep a coating from bonding, so we grind them off down to clean concrete and fill the nail holes. If the stains line up along one wall, that’s where water came in, and we find out why before the floor gets coated.
Berrien Springs is about 24 road miles from South Bend, roughly 34 minutes north. We run each job’s days in a row, and the moisture test before the quote is a short visit of its own.
We also serve Three Oaks, MI, near Lake Michigan, a couple of miles from the Indiana line.
Berrien Springs has a population of about 1,786. Here is what that means for the work we do here.
| Local fact | Detail |
|---|---|
| Prewar housing | 40% of Berrien Springs housing went up in 1939 or earlier. |
| Median build year | 1952, with 59% of the village's 886 units older than 1960. |
| Renters | Tenants occupy about 42% of homes in the village. |
| St. Joseph River | The village sits on the river, which hit record levels in February 2018. |
| Radon zone | Berrien County is in radon Zone 3, the group with the lowest potential. |
| Township and county | Berrien Springs is a village inside Oronoko Charter Township, Berrien County. |
Give us the rough size of the room, what the slab is doing now (stains, cracks, an old coating) and how you use the space. We call back with the system that fits and what would raise or lower the figure.
Basement slabs tested for moisture, ground and coated with epoxy, flake or polyaspartic for laundry rooms, rec rooms and home gyms around South Bend.
Epoxy, urethane cement and polished floors for plants, warehouses, kitchens, auto shops and showrooms in South Bend and Elkhart County.
Cracked, salt-pitted and spalled garage floors around South Bend repaired, left bare or made ready for a coating.
Concrete floors polished down to the stone, or just ground and sealed, for basements, shops, showrooms and warehouses around South Bend.
Peeling, chipped and worn epoxy floors around South Bend patched, recoated, or ground off and coated again.
Metallic epoxy floors poured over a ground, flattened slab for basement bars, kitchens on a slab, clean garages and small showrooms around South Bend.
Floor paint sits on top of the concrete, and it lets go when moisture pushes up from below. Once it starts to peel, all of it has to come off before anything new goes down.
Hairline cracks get filled and coated over. But if a crack keeps opening, or one side sits higher than the other, the slab is moving, and we find out why before any coating goes on.
Yes. Rental houses, shops and offices around the campus get the same testing and grinding as any other floor. For a rental, we work out a schedule with the owner, so tenants know which days the room is closed.
Once fully cured, a coated floor gives off nothing and cleans with the usual sanitizers. The coating's data sheet goes to the health department with your plans for review.
We grind the floor around it or patch the low spots so water runs to it again. A drain that sits above the floor leaves puddles a coating cannot fix.
Yes, if the slab passes the moisture test. Metallic epoxy shows every dip in the concrete, so an old floor gets patched and ground flatter than it would for a flake finish.
Quickest is a call to (574) 800-4334. Or tell us about the slab here and someone will phone you.